Electric oil pump

Abstract

The electric oil pump is no more than a small DC motor added to the every day oil pump to get oil flowing before the car engine starts up. Some oil pump have long necks, some have short necks that will need some redesign, but the long neck pumps will only need the DC motor attached to the pump. The mechanical pump will need at least two bolt down place on pump for DC motor to stay in place while in operation. Mechanics know that the first few revolutions of starting the engine, it has no oil PSI Therefore the oil light is on for a second or two and the engine is running and there is no oil PSI or proper circulation until the light on the dash goes out. The engine will be already running at this time on metal to metal until the light goes out. DC motor wires will go to the ignition switch and the oil sender that controls the light on the dash board. I have done my own independent search and being that I am a mechanic too, I found nothing like it on the market at this time.

What I claim is as follows:  
     
         1 ) any mechanical internal combustion engine oil pump.  
     
     
         2 ) Interal combustion engine oil pump made of abs lite weight PLASTIC (inside and out)(identical to metal ones).  
     
     
         3 ) One Faulhaber (DC brushless motor, series 3564)  
     
     
         4 ) 3564 motor with two bolt down positions (see FIG. 2 b )  
     
     
         5 ) 3564 motor will be added to a mechanical interal combustion engine oil pump (see FIG. 3)  
     
     
         6 ) 3564 motor with male shaft that will in the pump female gear shaft to turn the pump.  
     
     
         7 ) 3564 motor wires will connect to vehical ignition switch to cut on and off.  
     
     
         8 ) 3564 motor will need a fluctuater to keep it from running all the time (should come on and off like the heart beat)  
     
     
         9 ) 3564 motor will turn a max:9000 rpms or (150 rpms per second)  
     
     
         10 ) 3564 motor will need a electrical PSI gauge to bring the motor on and off @ about 45 psi while in operation.  
     
     
         11 ) 3564 motor added to the pump inside the motor.  
     
     
         12 ) 3564 motor all in one mounted on the out side of motor (see FIG. 5 
     
     
         13 ) 3564 motor has shaft coming out of one end, shaft is {fraction (1/4)} inches long.  
     
     
         14 ) Application qualify for small entity status  
     
     
         15 ) Application is nonprovisional  
     
     
         16 ) Application seeks world wide protection with an international patent status and number  
     
     
         17 ) Application may need to seek a patent design status later on if needed.